News

Home > News > Content
Ground Anchor Make
Oct 13, 2017

Anchor can be divided into the anchor pile and anchor, the anchor bar, drag the pits, lifting operation is commonly used in fixed anchor to drag rope, cable wind rope, hoist, guide pulley, etc., anchor wire rope, steel tube, reinforced concrete is commonly used in casting, logs and built-in buried.

Safety technical requirements for anchor production

1. The anchor shall be made according to design strictly according to the design, and shall not be overloaded when used.

2. The ground anchor pit should be dug into a right Angle trapezoid shape, and the Angle of slope and vertical line should be 15 degrees. The ground anchor depth is determined according to the comprehensive situation of the scene;

3. Drag the line and the horizontal plane Angle is 30 degrees, anchor foundation pit for point (i.e., the ground after the wire rope through the soil) in front of the pit deep within 2 meters on both sides of 2.5 times the scope and foundation pit, shall have a gutter, cable, underground pipeline and other structures and temporary digging ditches, etc.;

4. No water accumulation around the ground anchor;

5. The anchor is not allowed to follow the embedded parts.

The anchor pile can be divided into: the pile of the fixed vessel and the anchor pile of the construction project. The anchor pile of a fixed vessel is a kind of auxiliary device for water operation which is mainly used for fixed vessels. In construction engineering, the anchor pile is a supporting pile in the test pile. Generally a test pile with four anchor piles.

Construction project anchor pile

In construction engineering, the anchor pile is a supporting pile in the test pile. Generally a test pile with four anchor piles. The pile of anchor pile is rougher than the normal pile. Put a jack on the experiment pile. Place two supports at the center of the two anchors. High with the experiment pile jack. And there are three lines. Place a steel beam on three supports. The beam center is on the positive jack, and then put two steel beams on the beam. Three beam H shape placement. The four corners of H (i.e. the beam end) are connected with the anchor pile. When the jack is pressed, the pile is pressed and the anchor pile is pulled

Using engineering piles as a test of anchor pile vertical bearing capacity of the single pile has an impact on the test results, with the increase of pressure on the pile and anchor pile distance, will reduce the influence of anchor pile, engineering should guarantee a (anchor pile pressure on the pile distance) is large enough.

Anchor pile

The anchor pile of a fixed vessel is a kind of auxiliary device for water operation which is mainly used for fixed vessels. It consists of an anchor pile, which is made of a round shape tubular pile and a lifting ear, and the bottom of the anchor pile is inserted into a hole, and the end of the anchor pile is shaped like a cone. Its beneficial effect is that the anchor pile can keep the boat fast and secure on the shore.





Copyright © Shanghai Welfound International Trading Co.,Ltd All rights reserved.Tel: +86-21-61679676